Your position:Home > News

Brick flip spreader maintenance

2013-09-13

Brick-making machine flip spreader equipment during use, as a result of inflexible Rotary lock turning or not in place, you should check and adjust the nut, then check the following parts:
1. drive mechanism if the block occurs, such as block, belong to poor lubrication, it should be lubricated at the driving mechanism of active connections (or grease). If guide PIN is too tight, should be appropriately adjusting nut. If it is a loose connection, transmission or other variants, should be corrected.
2. turn on the lifting wire rope should be timely cleaned and coated with oil or grease, wire rope bends in particular.
3. use should be prevented from turning on spreaders dashboard indicates that the identification of paint peeling. Once discovered, to catch up the original instructions identify coating.
4. turn the spreader must not exceed rated capacity. (AAC devices)
5. all oil Cup including ratchet oil Cup, sliding on the oil cup oil Cup and spin lock box, connection main activity should be based on the use of timely lubricated.
6. turn spreader lifting processes should be smooth lifting and avoid lifting and other devices, such as hitting and deformation.
7. for the main load bearing element, ear rings, spin locks, plates and rigging shackle, in normal use, under clear conditions, at least once every 3 months, without cracks or severely deformed.

SKYPE: kevinlee02
QQ: 81573401
Tel: 0086-371-87091886
Fax:0086-371-87091887
E-mail:zzbona@zzbona.com

Name:
*
E-mail:
Message:

Copyright @ Bona enterprise. All rights reserved. Site Index Product Index

Design & Development by sinoart