Measures for the protection of brick machine making

Zhengzhou Bona completely block brick making commodity standards and serve the supply of high quality , small cement block machine funded dangerous , we gain big place with joy , mutual benefit and win ! Brick machine also needs protection , but also used in the proper way , Bona you explain small brick making machine protection.

Block brick protection :

1 , in normal operation only after feeding, with feeding should be uniform and should prevent mixing iron hard objects.

2 , before the shutdown is necessary to suspend feeding, the finished material crushing down and then stop the motor ;

3 , when viewing the fasteners are not loose , you should see the key pressed on both sides of the rotor plate hammer plate screws

4, to prevent loosening plate after plate exposed hammer two rotor body , and the body crashing , damage parts ;

5, soil brick making machine after repair or adjust the discharge opening , the rotor should be used to change human recognition of the rotor and there is no conflict with other parts and can be sensitive to changes in appearance stuck

6, when the cement brick making machine product particle size is too large, it should be shut down to view the state of wear plate hammer to prevent the rotor is worn .

7 , when the board needs to be adjusted due to wear hammer 180 ° use again , you should make every component of flat plate hammer and stick balanced to prevent the onset of back-breaking start sensation ;

8 , you should always check the bearing seal is not good, smooth inner bearing grease should bear once a month, every three months to be fully felt clean oil change and replacement of oil ;

9 , in order to ensure the safety of operating personnel and equipment , machinery repair job to stop , adjust and clean up operations, to stop all kinds of small doors open .